If a loaded Contender with firing pins armed is dropped or struck a blow without the internal hammer block safety engaged, it may discharge causing injury or death. If this manual operation is not performed, the internal hammer block safety will not be engaged. Whenever the hammer is cocked and then returned to uncocked position it is necessary to first set the External Manual Firing Pin Selector on safety position 2 and then perform one of the above set of procedures. Next pull up on the trigger guard spur until the action breaks open to reengage the internal hammer block safety. Ease the hammer down slowly until it rests on the selector lever. DO NOT ALLOW THE HAMMER TO DROP FREELY OR YOU MAY DAMAGE THE FIREARM. Hold your thumb on the hammer and pull the trigger. Set the External Manual Firing Pin Selector on safety position 2. This will release the hammer (allowing it to move forward) while keeping the hammer block engaged.Ģ. Then, with the thumb on the hammer, pull up on the trigger guard spur until the action breaks open. If, after cocking the pistol, the shooter decides not to fire, one of the following sets of procedures must be followed.ġ. Should you decide NOT TO FIRE the Contender" after the hammer has been FULLY COCKED, then you must take the following steps! If any problem or malfunction is noted the gun should be returned to the factory for service (see page 14). The action should be opened, the gun should be unloaded, the bore should be checked for obstructions, the action should be functioned to be sure that both safeties work properly that the trigger adjustment is proper (see pages 11 and 12) that the hammer functions normally and that there are no broken or deformed parts. If the Contender is dropped or struck a hard blow, the following steps should be taken. Always keep the muzzle of your Contender pointed down range. Do not rely on the safeties to overcome the danger of injury to yourself or others from careless handling or abuse of your Contender.ĭO NOT LOAD THE CONTENDER UNTIL YOU ARE READY TO FIRE IT. They are intended to be used in combination with common sense and safe gun handling practices. The safeties on the Contender are mechanical devices and are not foolproof. NEVER CLOSE THE ACTION ON A LOADED ROUND UNTIL YOU HAVE CHECKED AND ASSURED YOURSELF THAT THIS SELECTOR IS SET IN ITS SAFETY (UNARMED) POSITION. At all times, except for the instant before and after firing this selector must be set in safety position 2. If you are using a Rim Fire cartridge, see insert on right.Īfter the shot is fired, open the action, remove the fired round AND IMMEDIATELY RESET THE EXTERNAL FIRING PIN SELECTOR TO SAFETY POSITION 2. NOTE: Illustration shows Center Fire selection. Support the pistol with two hands as you move the External Manual Firing Pin Selector into armed position.įor Rim Fire cartridges, et selector in this position. Never cock the hammer until the instant before firing. Aim carefully at the target and fire the shot! 8 Set the External Manual Firing Pin Selector to the fire position required for your cartridge (Rim or Center Fire). When you are ready to fire, support the pistol with two hands (as pictured in Photo E). The hammer is drawn to cocked position and the External Manual Firing Pin Selector set to an armed position (position 1 or 3) only during the act of firing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |